3D Printed Clamp for keeping wires tight into a 24Volt 0.5Amp PoE Brick that comes with certain Ubiquiti Radios.
INFO on the brick used to model the bracket:
(Use Photo of PoE Injector to verify you are buying the correct model, no returns)
Takes 4+ cable ties to fasten everything, I use them with Thomas & Betts TyWraps. (Not Included)
These are 3D Printed PLA Plastic items.
They will warp if left in the sun for a short amount of time (~120+ deg F).
They should be installed only in locations with air conditioning or colder climates.
They burn nicely, do not use in locations next to other combustibles; If the PoE brick catches fire from lightning or an electrical fire, these would likely accelerate the fire even more.
If they are popular enough, I will be able to get a proper injection mold made and will be able to produce them much cheaper and make them out of a heat resistant plastic that doesn't warp when left in a hot car or on a window sill.
The design is Opensource and I put it on my GitLab page for if you have a 3D printer.
Of course buying them from me will save you time and hassle, and help fund Injection molds being produced for a better heat resistant version.
The .stl files can be found at:
I print them with a 0.6mm nozzle extra warm with an extra slow speed to make them nice and rigid.
They take about 1.5 hours each to print at the settings I use.
top of page
bottom of page